[scribus] Scribus 1.5.0 segmentation fault (building from source)

[Meho R.]

On 23.06.2011 03:08, Meho R. wrote:
> On 22.06.2011 21:42, Craig Bradney wrote:
>> On 6/22/11 8:38 PM, Meho R. wrote:
>>>> ----- Original Message -----
>>>> From: Craig Bradney
>>>> Sent: 06/22/11 07:15 PM
>>>> To: scribus at lists.scribus.net
>>>> Subject: Re: [scribus] Idiot wants to build 1.5.0 from source
>>>>
>>>>> OK, rebuild as jjj completed. These are the commands I used:
>>>>>
>>>>> mkdir ~/Software/Scribus/ mkdir ~/Software/Scribus/src/ mkdir
>>>>> ~/Software/Scribus/src/scribus_svn sudo mkdir /usr/local/scribus_svn
>>>>> cd ~/Software/Scribus/src/scribus_svn svn co
>>>>> svn://scribus.net/trunk/Scribus cd ./Scribus cmake
>>>>> -DCMAKE_INSTALL_PREFIX:PATH=/usr/local/scribus_svn make sudo make
>>>>> install
>>>>>
>>>>> All commands executed without error messages.
>>>>>
>>>>> It still won't launch; same results as before. This is the only
>>>>> clue:
>>>>>
>>>>> [jjj at Devil8 Scribus]$ cd /usr/local/scribus_svn/bin/ [jjj at Devil8
>>>>> bin]$ ./scribus Segmentation fault (core dumped)
>>>>>
>>>>> Suggestions?
>>>> mkdir -p ~/Software/Scribus/trunk/install/
>>>> mkdir -p ~/Software/Scribus/trunk/build/
>>>> mkdir -p ~/Software/Scribus/trunk/src/
>>>>
>>>> cd ~/Software/Scribus/trunk/src/
>>>> svn co svn://scribus.net/trunk/Scribus
>>>>
>>>> cd ~/Software/Scribus/trunk/build/
>>>> cmake -DCMAKE_INSTALL_PREFIX:PATH=~/Software/Scribus/trunk/install
>>>> ~/Software/Scribus/trunk/src/Scribus
>>>>
>>>> # note that will probably wrap but its 1 line
>>>>
>>>> make install
>>>>
>>>> Then run
>>>>
>>>> ~/Software/Scribus/trunk/install/bin/scribus
>>>>
>>>>
>>>>
>>>> Craig
>>>>
>>> Hmmm, interesting. I'm getting "segmentation fault" too. I've tried 
>>> to build both 1.4.0 and 1.5.0, same procedure (different svn source, 
>>> of course), but while both compile and install without a hitch, 
>>> 1.4.0 works, while 1.5.0 does not. 1.5.0 built couple of months ago 
>>> works fine. Has anything significant changed in these couple of 
>>> months, probably some newer libraries are needed? I've been testing 
>>> on Debian Wheezy, 64-bit.
>>>
>>>
>> Things change all the time.. try a make clean if you have not already,
>> or just nuke the build directory and try again.
>>
>> Try running within gdb to get a backtrace..
>>
>> Craig
>
> Here it is:
>
> [Thread debugging using libthread_db enabled]
>
> Program received signal SIGSEGV, Segmentation fault.
> 0x0000000000e10a14 in _cairo_user_data_array_set_data ()
>
> Next step?
>
> ___
Ah, sorry for partial (previous) email. I'll do some additional testing 
and add infos to existing bug reports regarding the same issue. Thanks.