[scribus] Collect for output

[Gregory Pittman]

On 04/23/2013 10:59 AM, John Jason Jordan wrote:
> I have two issues when I use Collect for Output. The document is a
> single page flyer created in 1.4.2 on Fedora 16, x86_64.
> 
> 2) I use a Junicode as my workhorse font, but this document was
> created with Arial. There are two text frames and, before placing the
> text in them, I set the default font for the frames to Arial. When I
> place the cursor in the text frames and do Select All, the font
> dropdown in the properties palette does not go blank, as it normally
> would if the selection contained more than one font. It stays "Arial."
> However, after using Collect for Output I find that Scribus collected
> the Junicode font as well. It must be somewhere in the document,
> but I can't find it. 

You can count on Scribus saving your default font even if you don't use
it anywhere. Anytime you create a text frame, it will be the default
font for that frame. It's challenging to get rid of this behavior.

Greg